Attaching A Cd Drive - Roland VIMA RK-300 Owner's Manual

Getting Ready

Attaching a CD Drive

(If using the KSC-48 dedicated stand)
1.
Turn the CD drive's power "AUTO."
0_fig.CDSW.eps
2.
Use the screws (3 x 8 mm) to attach the holders to
the CD drive.
0_fig.CDHolder.eps
Screws (3 x 8 mm)
3.
As shown in the illustration, fasten the CD drive
using the screws (4 x 16 mm) and the screw holes
located on the bottom of the RK-300.
0_fig.CDD.eps
Screws (4 x 16 mm)
30
4.
Use a USB cable to connect the CD drive's USB
connector to the EXT DRIVE connector on the RK-
300's rear panel.
fig.CDD-USB.eps
5.
Connect the AC adaptor included with the CD drive
to the CD drive's DC IN jack.
0_fig.CDD-Adap.eps
Cord hook
AC adaptor
Place the AC adaptor so the side with the indicator (see illustration)
faces upwards and the side with textual information faces
downwards.
The indicator will light when you plug the AC adaptor into an AC
outlet.
6.
Connect the AC adaptor to an AC outlet.
To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
• If you're using the KSC-48 dedicated stand, you can also
use the included CD tray to place the CD drive on the
front panel.
USB cable
To EXT DRIVE
connector
To AC outlet
Power cord