Replace Speed Control Linkage Or Speed Control Assembly; Remove And Replace Power Steering Control Cable - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Section 7.18: Replace Speed Control Linkage or
Speed Control Assembly
1) Check for proper linkage adjustment in
Section 6.24 before replacing part.
2) Remove control panel (see section 7.11 )
RETAINER
SPRINGS
3) Remove retainer spring from both ends of
linkage.
SCREWS
SPEED CONTROL
ASSEMBLY
4) Remove the two 5/16" hex head screws
holding control to handle assembly.
5) Reverse process to install a new linkage
and perform adjustment in Section 6.24.
32
www.mymowerparts.com
Section 7.19: Remove and Replace Power
Steering Control Cable
1) Remove fuel from fuel tank
2) Position blower auger end down.
3) Remove klik pin that secures wheel,
4) Remove wheel
POWER STEERING COVER
5/16" SCREWS
5) Remove hardware that secures the power
steering cover.
6) Cut wire ties that secure power steering
cable to handle, noting location of ties.
7) Remove spring and pin holding bellcrank.
8) Unhook cable from bellcrank. Remove
5/16" screw that secures trigger to handle.
Remove cable.
CABLE
9) Remove 5/16" screw that secures trigger to
handle.
10)Reverse process to install cable.
NUT &
WASHER
BELLCRANK
PIN
5/6" HEX HEAD
SCREW
TURN TRIGGER