Belt Guide; Klik Pin Position For Wheels On Power Steering Drive Snowthrower; Klik Pin Positions For Wheels On Standard Drive Snowthrower; Section 6. Adjustments - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
SECTION 6: ADJUSTMENTS

6.01 Belt Guide

6.11 Klik Pin Position for wheels on Power Steering Drive Snowthrower

6.12 Klik Pin Positions for wheels on Standard Drive Snowthrower

6.21 Adjustment for Drive System Control Rod
6.22 Adjustment for worn Traction Disc Ring
6.23 Adjustment for Auger Control Rod
6.24 Adjustment for Speed Control Rod
6.31 Procedure to add shim washer when Power Steering Slips
6.01 Belt Guide -
* Remove spark plug wire from plug.
* Engage auger lever and adjust clearance be-
tween belt and belt guide to 1/16" to 1/8".
6.11 Klik Pin Position for wheels on Power
Steering Drive Snowthrower
* This is the only position for the Klik Pin where the
Power Steering will work. The hole in the wheel
hub is NEVER used with Power Steering.
BELT GUIDE
1/16" to 1/8"
CLEARANCE
AUGER BELT
23
www.mymowerparts.com
6.12 Klik Pin Positions for wheels on Stan-
dard Drive Snowthrower
* To Push the snowthrower easily, the Klik Pin
should be through the outer axle hole, with the
wheel hub to the inside.
TRACTION BELT IDLER SPRING
* For the wheel to drive, the Klik Pin should be
positioned through both the wheel hub and inner
axle hole.