Disassemble Drive Plate / Drive Pulley Assembly (Shaft Lubrication); Replace Wheel Drive Axle / Gear - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
7.46 Disassemble Drive Plate / Drive
Pulley Assembly (Shaft Lubrication
INSTRUCTION )
SPRING
CLUTCH ROD
1) Unhook Spring from Clutch Rod (key 11)
2) Remove Hairpin Retainer (key 22) from the
Shift Plate Lever.
3) Remove Pivot Pin and separate Drive Plate
(key 26) from hex shaft.
LUBRICATE HEX SHAFT
4) Inspect parts for wear and replace if
necessary.
5) Lubricate all sides of Hex Shaft with metallic
anti-seize compound.
6) Reverse the order to reassemble.
NOTE: Lubrication of the Hex Shaft with
metallic antiseize compound is recommended
every 120 hours of operation. If this assembly
is removed, we recommend the hex shaft is
lubricated with anti-seize compound.
PIVOT PIN
HAIRPIN RETAINER
SHIFT PLATE LEVER
www.mymowerparts.com

7.47 Replace Wheel Drive Axle / Gear

1) Remove Frame Bottom Pan. Section 7.42.
2) Remove covers and disassemble power
steering on both sides if so equipped.
AXLE
BEARING
SCREWS
3) Remove the screws on the right side that
secure axle bushing to the frame.
4) Slide the axle out the right side and replace
damaged parts.
5) Reverse process to reassemble. Make
sure the square key, roll pin, and thrust
washer is located between gear and
bearing
42