Replace Chute Rotator Cable; Replace Chute Deflector Control - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Section 7.16: Replace Chute Rotator Cable
1) Remove control panel (see section 7.11
above, for Control Panel removal instructions)
CHUTE ROTATOR
CONTROL LEVER
2) Remove both 5/16
control to handle assembly.
CABLE ASSEMBLY
ROTATOR HEAD
3) Remove spring from deflector, if applicable.
4) Remove 9/16 nut holding control rotator
"
head to tubular support, and remove cable
assembly from the chute. The chute will not
be retained at the top, DO NOT drop chute.
5) Cut all cable ties noting locations, and
paying attention to the routing of cable
particularly at the lower handle.
6) Reverse process to install new cable. Install
new plastic ties to hold cables.
SCREWS
screws holding rotator
"
SPRING
CABLE ASSEMBLY
ROTATOR HEAD
9/16" NUT
www.mymowerparts.com
Section 7.17: Replace Chute Deflector Control
1) Remove control panel (see section 7.11).
NUT AND
WASHER
DEFLECTOR
CABLE
2) Remove the nut and washer that secure the
cable eyelet to the deflector.
3) Remove the nut, washer and bracket that
secure cable to the chute.
4) Remove both 5/16" screws that secure cable
assembly to the handle assembly.
5) Cut the cable ties that secure the cable to
the snowthrower, paying attention to the routing
of the cable and the location of ties.
6) Reverse process to install the cable and new
plastic ties.
31
SPRING
DEFLECTOR
CONTROL
LEVER
SCREWS
DEFLECTOR
CABLE
ASSEMBLY