Reassembly Of Auger Assembly; Replace Scraper Bar; Gearbox Repair Information - Husqvarna OHV Service Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

7.66 Reassembly of Auger Assembly

NOTE: Before re-assembling, clean impeller
shaft where the auger pulley will be installed
using emery cloth, and lubricate shaft end with
anti-seize.
1) Place auger bearings at ends of auger
with center notch in bearing toward housing
ends.
LEFT SIDE AUGER
30" AUGER WIDTH
2) Check the end of the auger flight. Stamped
into the metal is an "L" on the left side or "R"
on the right as well as the auger width.
3) With auger housing sitting on its back insert
gearbox / auger / impeller as an assembly
into place.
4) Reinstall screws to side of housing to
secure the auger bearings.
RIGHT SIDE
AUGER
AUGER BEARING
46
www.mymowerparts.com
IMPELLER SHAFT
5) Turn Auger assembly over, put antiseize
compound on impeller shaft before installing
pulley. Torque at 15-20 Ft.Lbs.
6) Reinstall belt and reattach auger assembly
to powerhead. (Section 7.61 or 7.31).

7.67 Replace Scraper Bar

NOTE: The Scraper Bar is reversible. Inspect
Scraper Bar on snowthrower before ordering a
replacement.
SCRAPER BAR
1) Tip snowthrower so that Auger is down and
handles are up.
2) Remove the nuts and carriage bolts holding
the scraper to the housing.
3) The scraper bar is reversible and can be
turned over and reinstalled once before
replacement is required.
4) Reuse carriage bolts and nuts to install
scraper bar.

7.68 Gearbox Repair Information

Replace worn or damaged parts. Replace gas-
ket. Use 750369 grease. Torque self-tapping
screw to 15 Ft.Lbs. max.
CARRIAGE BOLTS
AND NUTS