PERIODIC MAINTENANCE AND ADJUSTMENT
1. License plate light bulb
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
7
Front wheel
To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Place the vehicle on the center-
stand.
2. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
3
2
1
1. Front wheel axle pinch bolt
2. Wheel axle
3. Brake caliper bolt
7-36
EAU24360
3. Remove the brake hose holder on
each side by removing the bolt and
nut.
EAU40201
4. Remove the brake caliper (togeth-
er with the reflector) on each side
EWA10821
by removing the bolts. NOTICE:
Do not apply the brake after the
brake calipers have been re-
moved, otherwise the brake
pads will be forced shut.
1. Brake hose holder
2. Bolt and nut
3. Brake caliper bolt
4. Brake caliper
5. Reflector
5. Pull the wheel axle out, and then
remove the wheel.
[ECA11051]