Table of Contents
Advertisement
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the
beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
6. Touch the static-protective package that contains the drive to any unpainted
metal surface on the computer; then, remove the drive from the package and
place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Note: You might find it easier to install the new drive into the opening in the
front and then attach the cables.
8. Install the drive in bay 2 or bay 3.
To install the drive in bay 2, complete the following steps. To install the optional
diskette drive in bay 3, go to page 47.
a. Remove the large drive retainer clip that is attached to the inside of the top
portion of the bezel door. Pull outward (to the left) on the drive retainer clip
release tab to release the drive retainer clip, and lift it off the bezel.
Chapter 4. Installing optional devices
45
Advertisement
Table of Contents
