IBM 92296GU - IntelliStation M - Pro 9229 User Manual page 59

e. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and dual inline memory modules (DIMM).
f. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
If you have other devices to install do so now; otherwise, go to "Completing the
installation" on page 53.
To install an optional diskette drive in bay 3, complete the following steps:
a. Lift up on the bottom edge of the internal drive-bay bracket and rotate the
bracket out of the computer.
b. Remove the small drive retainer clip that is attached to the bottom of the
drive cage. Slide the drive retainer clip to disengage it from the drive cage;
then, snap the drive retainer clip into the screw holes on the side of the
drive.
c. Slide the drive into the front of the bay until it snaps in place.
Drive retainer
clip
d. Determine whether the drive is a IDE, SATA, or SAS device; then, connect
one end of the applicable signal cable into the back of the drive and make
sure that the other end of this cable is connected into the applicable IDE,
SATA, or SAS connector.
e. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and dual inline memory modules (DIMM)
f. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
If you have other devices to install, do so now; otherwise, go to "Completing the
installation" on page 53.
Installing a drive in bay 4, 5, or 6
To install a hard disk drive in bay 4, 5, or 6 complete the following steps:
Chapter 4. Installing optional devices
47