IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual page 144

1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Remove microprocessors, voltage regulator modules and terminator cards
11. Remove memory card.
12. Press the assembly inward at the cutouts to release the notches.
13. Lift the assembly out of the shuttle.
14. To install the new Processor/PCI board, reverse the above procedure.
134
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
1
Cutouts
2
Processor/PCI Backplane assembly
3
Microprocessors
Power-off the server, if it is on.
Disconnect the power cord for each power source from the electrical outlet.
Attention: The presence of ac standby power might result in damage to the
hardware unless you disconnect the power cord for each power source from the
electrical outlet.
Remove the top cover (see "Removing the top cover" on page 62).
Disconnect the shuttle (see "Disconnecting the shuttle" on page 128.)
Remove the shuttle (see "Removing the shuttle" on page 135).
Disconnect the power cable.
Disconnect the front fan cable.
Disconnect the rear fan cable.
Remove any hot-plug adapters (reverse the steps in "Installing a hot-plug
adapter" on page 64.)
(reverse the steps in "Installing a microprocessor kit" on page 73.)
Note: Lift the assembly at an angle for easier removal.