IBM 86655RY - Netfinity 7600 - 8665 Hardware Maintenance Manual page 112

9.
102
Hardware Maintenance Manual: Netfinity 7600 – Type 8665 Models 1RY, 2RY
Note: The graphical user interface (GUI) program files for DMI Browser, ECC
Memory Setup, System Partition Access, RAID Manager, and Predictive
Failure Analysis will be installed regardless of whether the system has a
DMI Service Layer, ECC Memory, a System Partition, a RAID adapter, or a
PFA-enabled disk drive. This enables a network administrator to remotely
access these services on other systems within a network. However, the
base program that enables local use of the service will be installed only if
the required hardware or system configuration is present.
Configure the Network Drivers.
If the installation configuration allows for network access, enter information
regarding the communication protocols that are supported by the system. The
Network Driver Configuration window will appear.
Follow these steps to continue configuring the system:
a. Enter a System Name.
Enter a name for the system in the System Name field. This name will help
other Netfinity Manager users identify the system on the network.
b. Select a Network Driver.
Select one of the available Network Drivers that are displayed in the Network
Drivers field. Once selected, the Network Driver will assign a network
address to the system.
Notes:
1)The fields that appear beneath the Driver Enabled check box will change
depending on which Network Driver has been selected.
2)When enabling the IPX or TCP/IP Network Driver, the network address
cannot be altered and it will not appear on the screen. No field will