Brother MFC5100C Service Manual page 217

WSW46 (Monitor of power ON/OFF state and parallel port kept at high)
Selector
No.
1
Monitoring the PC ON/OFF state
2
Parallel port output pins kept at
3
high level
4
Not used.
5
6
Delay time at the start of scanning
|
for making a single copy
8
NOTE: Selector 3 is applicable only to models equipped with a parallel interface.
NOTE: Selectors 6 through 8 are applicable only to models equipped with a flat-bed scanner.
Selectors 1 and 2: Monitoring the PC ON/OFF state
For the related functions, refer to WSW36, selectors 2 and 3.
Selector 3: Parallel port output pins kept at high level
Setting this selector to "0" will keep all parallel output pins of the facsimile equipment at high
level. Use this setting if Resource Manager (bundled with MFC models) installed to WindowsNT
running on the connected PC fails to monitor the power ON/OFF state of the facsimile equipment.
Selectors 6 through 8:
According to the setting made by these selectors, the MFC models may delay the scanning start
timing to prevent the carriage drive vibration from affecting the document scanning. No setting
change is required unless otherwise specified by Brother.
Function
Delay time at the start of scanning for making a single copy
41
Setting and Specifications
No. 1 2
0 0 : Disabled
0 1 : Monitor SELECT IN
1 0 : Monitor STROBE
1 1 : Monitor both SELECT IN and
STROBE
0: Enabled
No. 6 7 8
0 0 0 : No delay time
0 0 1 : 1 sec.
0 1 0 : 2 sec.
0 1 1 : 3 sec.
1 0 0 : 4 sec.
1 0 1 : 5 sec.
1 1 0 : 6 sec.
1 1 1 : 7 sec.
1: Disabled