Brother MFC5100C Service Manual page 181

Selectors 6 and 7: Dial tone detection in PABX
These selectors activate or deactivate the dial tone detection function which detects a dial tone
when a line is connected to the PABX.
Setting both of these selectors to "1" activates the dial tone detection function so that the
equipment starts dialing upon detection of a dial tone when a line is connected.
Other setting combinations deactivate the dial tone detection function so that the equipment starts
dialing after the specified WAIT (3.5, 5.0, or 7.0 sec.) without detection of a dial tone when a line
is connected.
Selector
No.
Earth function in transfer
1
facility
2
| Not used.
4
5
Earth time length for earth
function
6
7
Break time length for flash
function
8
NOTE: Selectors 1 and 5 through 8 are not applicable in those countries where no transfer facility is
supported.
Selector 1: Earth function in transfer facility
This selector determines whether or not the earth function is added to the transfer setting menu to
be accessed by the function switch.
Selectors 5 and 6: Earth time length for earth function
These selectors set the short-circuiting time length of the telephone line (La or Lb) to ground.
This setting is effective only when the earth function is selected for the R key by using the
function switch.
Selectors 7 and 8: Break time length for flash function
These selectors set the break time length.
This setting is effective only when the flash function is selected for the Speed Dial key by using
the function switch.
WSW04
(TRANSFER facility setting)
Function Setting and Specifications
0: Provided
No. 5 6
0 0 :
0 1 :
1 0 :
1 1 :
No. 7 8
0 0 :
0 1 :
1 0 :
1 1 :
5
1: Not provided
200 ms
300 ms
500 ms
700 ms
80 ms
110 ms
250 ms
500 ms