Brother MFC5100C Service Manual page 212

Selectors 6 through 8:
At the start of reception, if the equipment detects the frequency of calling signals (Ci) specified by
selectors 1 through 4 of WSW14, it will start the ringer sounding. When doing so, the equipment
may fail to detect the calling signals normally due to noises superimposed at the time of reception.
To prevent it, use selectors 6 through 8 of WSW36.
If the equipment detects higher frequencies than the lower limit specified by these selectors, it will
regard them as noise and interpret that detecting state as being normal, allowing the ringer to keep
sounding (until the equipment starts automatic reception of FAX data if in the FAX mode or enters
the TAD mode if set in the TEL mode, according to the preset number of ringers).
Selector
No.
Printout of the stored image
1 data of an unsent document
onto an error report
Erasure of the stored image
data of an unsent document at
2
the time of the subsequent in-
memory message transmission
3
| Not used.
8
Selector 1: Printout of the stored image data of an unsent document onto an error report
This selector determines whether or not the 1st-page image data of a document will be printed out
onto the error report if the document image data stored in the temporary memory cannot be
transmitted normally.
Selector 2: Erasure of the stored image data of an unsent document at the time of the subsequent
in-memory message transmission
If in-memory message transmission fails repeatedly when selector 1 is set to "1," the temporary
memory will be occupied with image data. Setting selector 2 to "1" will automatically erase the
stored 1st-page image data of an unsent document at the time of the subsequent in-memory
message transmission only when recording paper or toner runs out.
Lower limit of frequency to be ignored after detection of calling signals (Ci)
WSW37
(Function setting 15)
Function Setting and Specifications
0: No
0: No
36
1: Yes
1: Yes