Setting up your system
This section describes how to get your system up and running. It includes instructions for
installing or replacing the ribbon and tape supplies.
Unpacking and setting up the printer
Your system is so easy to set up, you'll be creating labels in just minutes! Follow these steps to get
started:
1) Remove the bag from around the printer.
2) Press the red cover release button and raise the printer cover up and away to the left.
The release button is located on the lower right side of the printer.
Printer cover
Cover release button
3) Remove and discard the foam piece that surrounds the printhead inside the printer.
1-2
Setting up your system