Correcting Multiple Line Problems - Brady POWERMark User Manual

Correcting multiple line problems

As you type, the system calculates how many lines will fit on the installed supply and within the
specified length (if you previously entered a label length). If you have entered too many lines, the
system displays one of several messages describing the error:
• If you start a new line, and that line will not fit on the tape you have installed, the following
message displays. This message also displays if you enter more lines than will fit on one label
(the maximum is 42).
• If the text you enter won't fit in the specified length, this message displays:
To fix the above problems, you can:
• Select a smaller type size. See
• Change the line spacing to Tight as described in
• Press the New Area key to create a new area on the current label.
• Use fewer lines on the label.
If you have a continuous color monochrome ribbon installed and you then add a second
color to the label, if your existing text already exceeds the maximum for multi-color
output, you'll see the "Text too long message." shown below:
The maximum multi-color output is:
• 23.6 inches if your system has been upgraded with additional memory
• 14 inches if it has the standard memory allotment
You can find out whether your system has additional memory by checking the Hardware
version on the Status window. See
When you press any key to continue, the message disappears. To fix this problem, you can
either reduce the length of the text, or install a paneled ribbon. For information about paneled
ribbons, see
Selecting ribbon type
2-8
Type too large or too many lines
Text too long
Changing type size
Text too long for more than one color.
Press any key to continue.
Checking system status
on page 4-5.
on page 3-4.
Changing the look of the label
on page 1-29 for instructions.
Adding lines, labels and areas to freeform labels
on page 3-13.