Setting Up Your System As A Hardware Device - Brady GLOBALMARK User Manual

Setting Up Your System as a Hardware
Device
Before you can use a PC to print to your label printing system or to
transfer files, your label printing system must be set up as a new
hardware device.
To set up your label printing system as a hardware device
1. Before turning on the power for either your label printing system or
2. Turn on your label printing system.
3. When you see the Main Menu screen, turn on the PC.
4. The operating system on the PC automatically detects your label
Note:
5. When the PC procedure prompts you for the location of the device
6. Follow the prompts on your PC. The PC reads and installs the
Note:
Your PC is now set up to communicate with your label printing system.
your PC, connect one end of the USB cable to the printer and the
other end to a USB port on the PC. See Figure 2-2 on page 2-4 for
an illustration.
printing system. Follow the PC prompts and instructions for setting
up your printer as a new hardware device.
If your PC is not "Plug & Play," and does not automatically
detect the label printing system, try adding the printer through
the PC Control Panel. On the Control Panel, choose Add/Remove
Hardware, and follow the PC prompts for "Add a New Device."
driver files, insert the CD-ROM labeled GlobalMark Product CD in
the CD-ROM drive of the PC, and enter the address for the CD-ROM
drive when prompted.
correct drivers.
You may need to restart both systems after installation is
complete.
12-3
Connecting to a PC