Extended System Commands (Stx K); Enter Label Formatting Command (Stx L); Set Printer To Metric (Stx M) - Brady TLS PC Link Programmer's Manual

Sample:
<SOH>D
<STX> IBpTest <CR> data...data
<STX>H
The above sample instructs the printer to receive an 8-bit .PCX image sent by 8-
bit data, named 'Test'. It disables immediate commands first, then re-enables
them after.
Feedback possibilities: 0,1,2,3,4

Extended System Commands (STX K)

This command allows for expansion of the DPL-system commands.

Enter Label Formatting Command (STX L)

This command switches the printer to the label-formatting command input mode.
Once in this mode, the printer expects to receive field record definition and label-
formatting commands until command E or X is received. System-level
commands will be ignored until the label formatting is terminated with E or X.
Immediate commands will be accepted, but if immediate commands are disabled,
they could get misinterpreted as a label format command. See label-formatting
commands for additional information.
Sample:
<STX>L
Feedback possibilities: 0,1,2

Set Printer to Metric (STX m)

This command sets the printer to measure in metric. When this command is sent,
all measurements will be interpreted as metric values in terms of mm/10, (e.g.,
<STX>M0500 will be interpreted as 50.0mm.). See <STX>n.
Sample:
<STX>m
Default setting: Inches
Feedback possibilities: 0,1,2
18
TM
TLS PC Link Programmer's Guide