Print Last Label Format (Stx G); Enable Soh Commands (Stx H) - Brady TLS PC Link Programmer's Manual

Print Last Label Format (STX G)

This command prints a previously formatted label. This command is used when
there is a label format in the buffer. The STX E command is used to enter the
quantity. (If the STX E command is not used only one label will print.)
Sample:
<STX>G
Feedback possibilities: 1,2,6,7,8,A,B,C,D,E,F,G,H

Enable SOH Commands (STX H)

This command is used to enable Immediate Commands on power-up or to re-
enable them if they have been turned off for downloading image data. If feedback
characters are enabled, a code will be sent out from the printer to inform the host
that Immediate Commands are again enabled.
Sample:
<SOH>D
<STX> IBpTest <CR> data...data
<STX>H
The sample above will disable SOH commands, download a PCX image, then re-
enable SOH commands.
Feedback possibilities: 1,2,5
16
TM
TLS PC Link Programmer's Guide