Disable Feedback Characters (Stx A); Enable Feedback Characters (Stx A) - Brady TLS PC Link Programmer's Manual

System Level Command
Set Printer to Inches (STX n)
Set Start of Print Offset (STX O)
Horizontal Alignment Offset (STX o)
Clear All Memory (STX Q)
Printhead Dot Pattern Test Label (STX T)
Send Binary Touch Cell Data (STX t)
Label Format Field Replacement (STX U)
Send ASCII Touch Cell Data (STX V)
Printer's Firmware Version Information (STX v)
Request Memory Information (STX W)
Delete File (STX x)
Pack Memory (STX z)

Disable Feedback Characters (STX A)

This command disables the feedback ASCII characters.
Sample:
<STX>A
No feedback response

Enable Feedback Characters (STX a)

This command enables the feedback ASCII characters. These feedback
characters contain valuable information about system errors, printing completion,
and enabling of immediate commands. These characters are listed in Appendix
A. The printer is initialized with feedback characters turned off. When feedback
characters are enabled, all commands will have a response associated with them.
When there are no errors, the response will be '0'. There is no response to the
<STX> a command.
Sample:
<STX>a
No feedback response
12
TM
TLS PC Link
Page
19
19
20
20
21
22
24
25
25
25
26
26
Programmer's Guide