Lenovo RD120 - ThinkServer - 6447 User Manual page 60

10. Firmly press the ServeRAID-8k SAS controller straight down into the connector
11. Remove the battery from the ServeRAID-8k SAS Controller package.
12. Slide the battery mounting tabs into the battery mounting clips on the server
13. Connect the battery to the ServeRAID-8k SAS Controller.
14. Replace the air baffle over the DIMMs (see "Installing the DIMM air baffle" on
15. Replace the riser-card assembly (see "Installing the riser-card assembly" on
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 74.
Notes:
1. When you restart the server for the first time after you install a ServeRAID-8k
46
ThinkServer RD120 Types 6444, 6445, 6446, and 6447: User Guide
1
RAID controller
2
Battery cable
3
Battery
9. Turn the new ServeRAID-8k SAS controller so that the keys on the bottom
edge align correctly with the connector.
by applying pressure on both ends of the controller simultaneously. The
retaining clips snap into the locked position when the controller is firmly seated
in the connector.
Note: If there is a gap between the controller and the retaining clips, the
controller has not been correctly installed. In this case, open the retaining clips
and remove the controller; then, reinsert the controller.
wall that is next to the ServeRAID SAS controller connector.
page 38).
page 34).
SAS controller, the monitor screen remains blank while the controller initializes
4
Battery mounting tabs
5
Battery mounting clips
6
Battery cable connector