Bosch 2000 Series Program Entry Manual page 19

Table of Contents

Advertisement

2000 Series | Program Entry Guide | 4.0
3 Non-Fire Group
Default:
0
Selection:
0 to 9, B to F
1 to 8
Non-Fire alarm from Points 1 to 24.
9 or 0
Non-Fire alarm from key A, B, or C.
Refer to Section
There are no Pulse Format versions of
the Modem II Alarm recent Close,
Alarm Cross Point, or Exit Alarm
Reports. All occur as Alarm Reports.
The Cross Point feature creates two
point alarms. Refer to Section 11.0 Point
Codes.
4 Pt Trbl Group
Default:
0
Selection:
0 to 9, B to F
Trouble, Missing, Bypass, or Swinger
1 to 8
Bypass Reports from Fire and Non-Fire
points combined.
Multiple trouble conditions can create
duplicate Trouble Reports. For
example, a point can send a trouble for
a open sensor loop, then a trouble for
missing.
5 Restoral Group
Default:
0
Selection:
0 to 9, B to F
Restoral on points 1 to 24, Fire and
1 to 8
Non-Fire combined.
6 Closing Group
Default:
0
0 to 9, B to F
Selection:
Closing Report when a passcode is not
0
required to turn system on (refer to
Passcode Rquired
15.0 Passcodes) or a keyswitch is used.
Closing Report with User ID for users 1
1 to 8
to 8.
Bosch Security Systems | 7/05 | 35114F
Receiver
7.0
ABC Keys.
prompt in Section
7 Opening Group
Default:
0
Selection:
0 to 9, B to F
Opening Report when keyswitch is
0
used, or Part On No Delay, or Part On
with delay.
Opening Report with User ID for users
1 to 8
1 to 8.
8 Cancel Group
Default:
0
Selection:
0 to 9, B to F
0
Cancel Report when keyswitch is used.
1 to 8
Cancel Report with User ID for users 1
to 8.
9 Sys Trbl Group
Default:
0
Selection:
0 to 9, B to F
1
Reports an unsuccessful attempt to connect a
remote programmer.
2
Reports an unsuccessful attempt to connect a
remote programmer.
3
The system automatically reset. Call Bosch
Security Systems if reports persist.
4
Not used.
5
Not used.
6
Reports missing battery.
7
Reports low battery.
8
No AC power to system. Control panel is
running on battery.
9
Communication Failure event for Phone 1.
B
Communication Failure event for Phone 2.
C
RF tamper (points or receiver).
D
RF low battery.
E
RF receiver 7 trouble.
F
RF receiver 8 trouble.
EN | 19

Advertisement

Table of Contents
loading

Table of Contents