Bosch 2000 Series Program Entry Manual page 16

2000 Series | Program Entry Guide | 4.0
Table 2: continued
Modem II Report
CLOSING REPORT
CLOSING REPORT ID
001 (-008)
COMM FAIL
PHONE (1-2)
COMM RESTORAL
PHONE (1-2)
DURESS
ID 008
EXIT ERROR 001
(-024)
FIRE ALARM POINT
001 (-099)
FIRE ALARM CROSS
POINT 001 (-024)
MISSING ALARM POINT
001 (-024)
MISSING TROUBLE
POINT 001 (-024)
OPENING REPORT
OPENING REPORT ID
001 (-008)
OPEN FROM ALARM
OPEN FROM ALARM ID
001 (-008)
PERM INST ARMED
PERM INST ARMED ID
001 (-008)
PERM DLAY ARMED
PERM DLAY ARMED ID
001 (-008)
Bosch Security Systems | 7/05 | 35114F
Receiver
Description
Closing Report when passcode is not used. Refer to the Passcode Rquired prompt in Section
15.0 Passcodes. Using a Keyswitch or a remote programmer also sends this Closing Report
with no user ID.
Closing Report with user ID for users 1 to 8.
Communication Failure event. Refer to Phone 1, Phone 2 in Section 2.0 Phone.
Successful communication after a Communication Failure event. Refer to Phone 1, Phone 2 in
the Section 2.0 Phone.
Passcode 8 used to turn the system on, turn the system off, or to silence an alarm. Refer to the
Code 8 = Duress prompt in Section 15.0 Passcodes.
When a point is faulted at the end of exit delay it generates an Exit Alarm.
Exit Alarm Report from Points 1 to 24.
Fire Alarm Report from Points 1 to 24.
Cross Point Fire Alarm Report from Points 1 to 24.
Missing Non-fire Controlled point, point is on (armed). Alarm response locally.
Missing Non-fire Controlled point, point is off (disarmed), or 24-hour Non-fire point. Trouble
response locally.
Turning the system off with a keyswitch or a remote programmer sends this Opening Report
with no User ID.
Opening Report with User ID for users 1 to 8.
Turning the system off after an alarm with a Keyswitch point or a remote programmer sends
this Opening Report with no User ID.
Opening Report after an alarm with User ID for users 1 to 8.
Remote programmer used to turn the system Part On with No Delays, or user turned the
system Part On with No Delays and no passcode required. Refer to the Passcode Rquired
prompt in Section 15.0 Passcodes.
User with ID shown (1 to 8) turned the system Part On with No Delays.
Remote programmer used to turn the system Part On (with Delays), or user turned the system
Part On with Delays and no passcode required. Refer to the Passcode Rquired prompt in
Section 15.0 Passcodes.
User with ID shown (1 to 8) turned the system Part On (with Delays).
EN | 16