Battery And Charger - Sanyo Juno User Manual

Battery and Charger

WARNING Use only manufacturer-approved batteries and chargers
with your phone. The failure to use a manufacturer-
approved battery and charger may increase the risk that
your phone will overheat, catch fire, or explode, resulting
in serious bodily injury, death, or property damage.
Battery Capacity
Your phone is equipped with a Lithium Ion (Li-Ion) battery. It
allows you to recharge your battery before it is fully drained. The
battery provides up to 4.8 hours of continuous digital talk time.
For a quick check of your battery level, glance at the battery
charge indicator located in the upper-right corner of your phone's
display screen. When there are approximately five minutes of talk
time left, the battery icon (
warning tone.
After an additional five minutes or so, the phone sounds a
warning tone three times and then turns off.
Note Long backlight settings, searching for service, vibrate mode,
browser use, and other variables may reduce the battery's talk
and standby times.
) turns red and the phone sounds a
Tip Watch your phone's battery level indicator and charge the battery
before it runs out of power.
Installing the Battery
See "Setting Up Your Phone" on page 2.
Removing the Battery
1.
Make sure the power is off so that you don't lose any stored
numbers or messages.
2.
Slide the battery release latch in the direction of the arrow
( ), pull the battery cover up, and remove it (
3.
Lift the battery up and remove it from the phone (
WARNING Do not handle a damaged or leaking Li-Ion battery as
you can be burned.
).
).
2A. Phone Basics 11