Running Express Setup - Cisco IE-3000-8TC Getting Started Manual

Cisco IE 3000 Switch Getting Started Guide
Step 4 Push in the upper and lower module latches to
secure the module to the switch.
Step 5 If you are installing a second module, repeat Step 2 to Step 3, but secure the second module
to the right side of the first module.

Running Express Setup

OL-16234-01
When you first set up the switch, you should use Express Setup to enter the initial
IP information. Doing this enables the switch to connect to local routers and the
Internet. You can then access the switch through the IP address for additional
configuration.
You need this equipment to set up the switch:
A PC with Windows 2000, Windows Vista, Windows 2003 or XP installed.
•
A web browser (Internet Explorer 6.0, Internet Explorer 7.0, or Firefox 2.0)
•
with JavaScript enabled.
A straight-through Category 5 Ethernet cable to connect your PC to the
•
switch.
Disable any pop-up blockers or proxy settings in your browser software and any
wireless client running on your PC.
Cisco IE 3000 Switch Getting Started Guide
5