Loading Paper Into The Multi-Bypass - Olivetti d-Copia 20 Operation Manual

5
Set the paper flush against the left-hand wall of the drawer.
IMPORTANT
• There is a sticker (1 in the illustration) indicating paper capacity
attached to the inside of the drawer. Do not load paper above this
limit.
• When loading paper into the drawer, make sure that the copy side is
facing upward. (The copy side is the side facing upward when the
package is opened.)
• Check that the length adjustment plate makes secure contact with
the paper. If there is a gap, adjust the position of the length adjust-
ment plate.
6
Set the supplied paper size sheet so that the size of the
paper loaded can be checked by looking at the front of the
drawer.
CHAPTER 3 HOW TO LOAD PAPER
7
Gently push the drawer back in.
* Check that the paper is kept under the claws of the drawer.
If not, reload the paper.
NOTE
• Before leaving the copier in disuse for a prolonged period of time,
remove the paper from the drawer(s) and seal it in its original
packaging to protect from moisture.

(3) Loading paper into the multi-bypass

Special paper as well as standard paper can be loaded into the multi-
bypass. When copying onto transparencies or thick paper, be sure to
use the multi-bypass.
NOTE
• Number of sheets of standard paper, colored paper and letterheads
that can be loaded into the multi-bypass differ depending on the
paper size.
11" x 17" and 8 1/2" x 14" (A3, B4 and Folio): 25 sheet
11" x 8 1/2" and 5 1/2" x 8 1/2" (A4 to A6R): 50 sheets
• The types of special paper and the number of sheets that can be
loaded in the multi-bypass are:
· Transparencies: 1 sheet
2
· Standard paper (120g/m , 160g/m
IMPORTANT
• When loading special paper such as transparencies and thick paper
in the multi-bypass, select the type of paper in "6 PAPER TYPE
(BYPASS)" on page 6-14.
1
Open the multi-bypass.
2
): 1 sheet
3-2