The Print Head; Replacing The Print Head - Olivetti CopyLab 200 User Manual

The Print Head

You can use the colour print head provided or a black print head, which may be ordered separately.
This chapter describes the following procedures:

• Replacing the print head

• Aligning the print head
• Cleaning the print head
• Taking care of print heads
Replacing the Print Head
1. If you are using the machine as a photocopier, press
operator panel.
If you are working in multifunctional mode, click on the Printer
Monitor Printer Care tab and click on the Change button).
The print carriage will move to the insertion/removal position.
2. Open the machine's front cover by pushing it to the left, to gain
access to the print carriage compartment.
3. By pushing the tab on the rear part of the print head seat backwards
(1), release (2) and remove the worn print head (3).
4. Open the sealed print head pack and remove the print head
from it.
5. Peel off the protective film.
Take care not to touch the electrical contacts (gold plate) or the print nozzles, and do not rest the
print head on them.
6. With the gold electrical contacts facing the rear of the machine, insert
the print head.
7. Fix the print head in position in the print carriage by pressing it towards
the rear of the machine until it clicks into position, then close the cover
by pushing it to the right.
8. Press
: the LCD shows INIT. PRINT HEAD on the top line, and
PLEASE WAIT on the bottom line.
The Print Head
on the
9