Olivetti CopyLab 200 User Manual page 44

Problems when printing
Print test did not run.
No pages exit from
multifunctional copier
Multifunctional copier produces a
blank page
Incorrect text/image placement on
page:
Colours not aligned correctly
Printout is slanted
or skewed
Text or graphics are cut off at the
edges of the page
44
Multifunctional copier not ready to print.
No paper in input tray.
Print head not inserted correctly or is
out of ink
Print head contact/jets require cleaning.
the Multifunctional copier is not selected as
output device.
No paper/printing media in the paper
tray.
Print head still has its protective tape.
Print head out of ink or print jets on
head require cleaning.
Wrong page orientation.
Print head is not aligned correctly.
Non-approved paper type or paper not
held correctly.
Incorrect margin settings
Incorrect paper size.
Portrait / Landscape
Paper not held correctly.
Switch off the multifunctional copier, wait a few seconds and then switch
it on again. Repeat the selection from Menu using the operator panel or
click the appropriate button in the Printer Care tab in the Printer Monitor.
The LCD shows CHECK PAPER.
Load paper/printing media in the paper tray, following the instructions
given in " Loading paper ".
The LCD shows INSERT PRINT HEAD.
Remove and/or re-insert the print head correctly, following the
instructions given in the Installation sheet, or in the " Replacing the print
heads " paragraph.
Run the Clean function from the Printer Monitor and/or clean the print
head contact/jets (see Cleaning the print heads ).
Open the Printers folder, click the multifunctional copier icon and then,
from the File menu, click Set As Default.
The LCD shows CHECK PAPER.
Load paper/printing media, following the instructions given in " Loading
paper ".
Remove the print head from the multifunctional copier and remove the
protective tape.
Always remove the protective tape from a new the print head
BEFORE inserting the head in the multifunctional copier. Failure to
do so may render the print head unusable and/or cause damage to
your multifunctional copier.
Try printing the test page to verify the print head condition, and if
necessary replace the empty head .
Check that the page orientation selected in your software program
matches the page orientation setting in the Properties dialog box of your
multifunctional copier driver, and that these both correspond to the page
size you are using.
Remember to align the print head whenever you replace it.
Make sure that the paper is of a manufacturer-approved type and that it
is loaded correctly in the paper tray and that the adjustable lateral guide
is properly closed against the paper.
Load only ONE type of paper at a time in the paper tray and make
sure this type is selected in the corresponding Properties dialog
box in your multifunctional copier driver.
Make sure margin settings for the document do not exceed the print line
length for the paper size you are using.
Check that the document you are printing will fit on the paper size you are
using.
Check that the page orientation selected is the correct one.
Make sure the adjustable lateral paper guide of the paper tray is closed
properly against the paper.
Troubleshooting