Olivetti CopyLab 200 User Manual page 43

Repetitive patterns are
visible on the copy
Paper wrinkled and very wet
White lines on the copy
Copied image seems to have
shifted or jumped
Copies streaked, smeared, or with
horizontal lines
Incorrect image placement on page
or edges cut off
Copies are crooked
Troubleshooting
Colour Intensity setting is inadequate.
Print head needs replacing.
Glass and/or under-side of copier cover
is/are dirty.
Poor quality original.
Document being copied is already a
copy, not an original.
Incorrect Paper Type setting
The print head jets may be clogged
Paper Type setting does
correspond to the media loaded in the
input tray (e.g. Paper Type is
Transparent but Plain paper is loaded
in the input tray.)
Page has very dark colours
The original has been folded.
Copier cover was lifted or uneven
pressure was applied to it during
copying.
Copying on the wrong side of the paper
Original not positioned correctly on
copier glass.
Wrong enlargement ratio
Wrong paper size
Original not placed correctly on the
copier glass.
Lateral guide on the ASF is not position
correctly against the paper/media
edges.
Press the Colour Intensity button to select better colour intensity.
Check the print head by printing the test page. If necessary, replace the
print head.
Remember to align the print head whenever you replace it.
Clean the glass and/or the underside of the copier cover with a soft,
damp cloth.
Some types of originals, such as newsprint or newspaper photos do not
copy well.
When material is reprinted, repetitive patterns may be visible on the
copy. Try to eliminate the patterns by reducing the copy size or by
placing the document at an angle on the glass.
Make sure that the paper type indicated on the LCD is the same as the
type of paper actually loaded in your multifunctional copier.
Run the Clean function: if the copy quality does not improve, remove and
clean the print head manually, then print a test page.
If necessary, replace the print head.
Remember to align the print head whenever you replace it.
not Change the Paper Type setting OR load the input tray with paper
indicated by the current setting.
Press the Colour Intensity button on the operator panel to lighten the
copy.
Countercrease the fold or place a book on top of the original to minimise
the fold.
Copy again, and do not to lift or press down on the copier cover while the
copy is being made.
Make sure to put the paper/print media is print-side down.
Make sure the original is aligned both horizontally and vertically with the
scale at the edge of the document glass.
The enlargement ratio currently selected is making the copy too large or
too small. Correct the setting.
The paper size setting currently selected does not correspond to that
loaded in the input tray. Load the correct paper size OR change the
setting.
Align the original correctly against the scale at the edge of the document
glass.
Position the guides correctly.
43