Table of Contents
Advertisement
A fault indicator light comes on but the wash programme
continues as normal.
Fault indicator
The Check drain
light flashes.
The Check inlet light
flashes.
The Excess
detergent check
light comes on.
The Main wash
indicator light is
flashing in the
programme
sequence display.
The
Anti-crease/Finish
indicator light
flashes in the
programme
sequence display.
A To switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to Finish .
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the wa-
ter inlet hose is
dirty.
Excessive foam
has built up during
washing.
There is a fault.
The position of the programme selector was altered after
the start of the programme. Turn the programme selector
back to the programme previously chosen.
Problem solving guide
Remedy A
Clean the fluff filter and the drain
pump as described in "Problem
solving guide - Opening the door in
the event of a blocked drain outlet
and/or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's
instructions on dosage given on the
packaging.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
35
Advertisement
Table of Contents
