A Fault Indicator Light Comes On But The Wash Programme Continues As Normal - Miele W 3203 Operating Instructions Manual

A fault indicator light comes on but the wash programme
continues as normal
Problem
The Check drain light
flashes.
The Check inlet light
flashes.
The Excess detergent
check light comes on.
The Main wash
indicator light is
flashing.
The Anti-crease/Finish
indicator light is
flashing.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the programme selector to Finish .
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the
water inlet hose is
dirty.
Excessive foam
has built up
during washing.
There is a fault.
The position of the programme selector was altered
after the start of the programme. Turn the programme
selector back to the programme previously chosen.
Problem solving guide
Remedy A
Clean the drain filter and the drain
pump as described in "Problem
solving guide - Opening the drum
door in the event of a blocked
drain outlet and/or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's
instructions on dosage given on
the packaging.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
35