MOTU UltraLite-mk3 Hybrid User Manual page 75

Output reverb send/return
The output reverb send (Figure 11-6) feeds the
signal for the output to the UltraLite-mk3's global
reverb processor, where it is merged with any other
signals being fed to the reverb. The reverb's output
can then be fed back into the mixer at various
return points, including the same output from
which it was sent (discussed below). The output
reverb send is disabled (grayed out) when the
reverb Split Point is set to Mix to eliminate the
possibility for feedback loops created by reverb
send/return loops. See "Split point" on page 89.
The output reverb return (Figure 11-6) feeds the
output of the UltraLite-mk3's global reverb
processor directly to the output. This includes any
other signals currently being fed to the reverb.
Output name
Channel focus
EQ/Dynamics graph
EQ/Dynamics controls
EQ/Dynamics
enable/disable
Output reverb
send/return
Talkback/listenback
enable/disable
Monitor group assign
Figure 11-6: The Outputs tab.
C U E M I X F X
Both the send and return occur after EQ and
dynamics processing, but before listenback and
talkback.
Talkback/Listenback
Click the Talkback or Listenback buttons
(Figure 11-6) to toggle whether the output pair is
included in the Talkback or Listenback group. See
"Talkback and listenback" on page 91.
Monitor group assign
Click the Monitor buttons (Figure 11-6) to toggle
whether the output pair is included in the Monitor
group. See "The Monitor Group" on page 90.
Outputs tab
EQ band selectors
LP/HP filter selector
Compressor selector
75