Connect Midi Gear - MOTU UltraLite-mk3 Hybrid User Manual

User guide for mac

Hide thumbs Also See for UltraLite-mk3 Hybrid:

User manual (112 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

Table of Contents

adjust these trims using CueMix FX, see "Input

trim" on page 73. To adjust the trims using the

front panel LCD:

1 Push the PARAM knob repeatedly until you see

CUEMIX in the LCD display.

2 Push the CHANNEL knob repeatedly until you

see "I:" (which stands for Input) in the CHANNEL

section of the LCD (Figure 3-3).

3 Turn the CHANNEL KNOB until you see the

desired analog input or input pair. For example,

analog inputs 1-2 appear as "I:An 1-2"

(Figure 3-3), which means Input analog 1-2.

4 From the factory, analog inputs are grouped in

stereo pairs (1-2, 3-4, etc.) If you need to split a pair

to program it as two individual mono inputs, turn

the PARAM knob until you see PAIR in the

parameter section of the LCD (Figure 3-3). Turn

the VALUE knob to choose MONO. Then turn the

CHANNEL knob again to select the desired input.

Figure 3-3: The settings for analog inputs 1 and 2 (as a pair).

5 After splitting the stereo pair, if necessary, turn

the PARAM knob until you see the TRIM

parameter in the LCD (Figure 3-4):

Figure 3-4: Setting the input trim for a TRS analog input pair.

6 Turn the VALUE knob to adjust the trim.

I N S T A L L I N G T H E U L T R A L I T E - M K 3 H Y B R I D H A R D W A R E

Separate main outs

The main outputs operate as an independent pair

(they don't share signal with any other output

pair). In a standard studio conﬁguration, the main

outs are intended for a pair of studio monitors, but

they can also be used as regular outputs for any

purpose. Their reference level is +4dB. Main out

volume is controlled by the VOL knob on the front

panel: push it repeatedly until you see MASTER

and then turn it to adjust the master volume

output. This knob can be programmed to control

any combination of outputs you wish.

S/PDIF

If you make a S/PDIF digital audio connection to

another device, be sure to review the digital audio

clocking issues, as explained in "Connecting and

syncing S/PDIF devices" on page 22.

The UltraLite-mk3 on-board mixer also supplies

12dB of digital trim adjustment for the S/PDIF

input pair, which can be adjusted from CueMix FX

("Input trim" on page 73) or the front panel (using

the same procedure as explained earlier for

"Quarter-inch analog input trims" on page 20.