Selecting / Deleting Direct Programming; Switching Tmc On/Off - Becker Traffic Pro 4720 Operating Manual

Navigation CD 8.X

Selecting / deleting direct programming

Only applies whenTMC is switched off.
Activate the TP menu.
Selecting: Press the multifunction button.
Using the right rotary control
mitter. After a short delay and without actuation, the selected
transmitter is accepted.
Deleting: Press the multifunction button.
Using the right rotary control
press to confirm. After a short delay and without actuation,
the direct programming is deleted.
Quit the TP menu.
Subject to errors and technical modifications
, select the desired TP trans-
, select and

Switching TMC on/off

You can find further information on TMC under
Note:
"Dynamic navigation with TMC" on page 31.
Activate the TP menu.
Switching on:
Press the multifunction button repeatedly until
is displayed.
If TMC is switched on, a traffic programme transmitter can-
not be selected freely. A TMC station is selected by the unit,
provided one can be received. This transmitter then corre-
sponds to the traffic programme transmitter.
Switching off:
Press the multifunction button repeatedly until
is displayed.
If TMC is switched off, a traffic programme transmitter can
be selected freely.
Note: Dynamic navigation functions (dynamic route, traf-
fic information) cannot be selected or called up.
36
Copyright by Becker GmbH, D-76303 Karlsbad