Dynamic Navigation With Tmc - Becker Traffic Pro 4720 Operating Manual

Dynamic navigation with TMC

Dynamic route guidance is not possible in all coun-
Note:
tries.
To use dynamic navigation and the functions de-
scribed below, TMC must be switched on, as de-
scribed under "Switching TMC on/off" on page 36.
When any route recalculations are made with active
dynamic route guidance, the navigation system may
request the Navigation CD (if the Navigation CD is
not already inserted).
Austria: The location and event code was made
available by ASFINAG and BMVIT.
What is dynamic route guidance?
Dynamic route guidance is used to calculate the route, taking
current traffic announcements into account.
The traffic announcements are transmitted by a TMC radio
station in addition to the radio programme and are received
and analysed by the navigation system. There is no charge for
receiving traffic announcements.
Subject to errors and technical modifications
Note: Traffic announcements are transmitted by radio sta-
tions, therefore we cannot accept any responsibility
for the completeness and correctness of the an-
nouncements
Activating dynamic route guidance
Dynamic route guidance can be started by selecting
in the route menu.
Can only be selected if TMC has been switched on or
Note:
is currently switched on. See "Switching TMC on/
off" on page 36.
If is not displayed immediately (display
or
must be selected by entering the route settings.
Dynamic route guidance is started after confirmation of
using the right rotary control
quent confirmation of
31
Navigation CD 8.X
), then
and subse-
.
Copyright by Becker GmbH, D-76303 Karlsbad