Destination Input Via Coordinates - Becker Indianapolis 7920 Operating Manual

Note:
By pressing the right rotary control
for more than 2 seconds without previ-
ously entering a letter, a list of the pos-
sible location centres will immediately
appear.
Destination input via
coordinates
If the geographical coordinates (latitude
and longitude) of a destination are
known, these can be entered and route
guidance to the destination started.
Select COORDINATES with the right
X
rotary control and press the control
to confirm.
Enter the latitude of the destination us-
X
ing the right-hand rotary control
Entries must be made in degrees, min-
utes, seconds and a direction as the
crow flies, e.g. 11°38'34 "N
X To confirm the entry, press and hold
the right-hand rotary control
more than 2 seconds.
or
Select the small tick
X
press the right rotary control
X Enter the longitude of the destination
using the right-hand rotary control
as described above.
X To confirm the entry, press and hold
the right-hand rotary control
more than 2 seconds.
or
Select the small tick
X
press the right rotary control
Note:
If the coordinates entered are located
beyond the boundaries of the digital
map, a message will appear notifying
you of this. The system cannot navigate
to a position beyond the boundaries of
.
the digital map.
.
The navigation system then requests a
for name to be entered for the entered coor-
dinates.
X Enter a name as described in "Storing
and briefly a destination in the destination mem-
. ory" on page 132.
The program then switches to the Route
menu.
Route guidance can now start.
for
and briefly
.
Navigation mode
129