Entering A Destination - Becker Indianapolis 7920 Operating Manual

Entering a destination

The last location entered is displayed.
If you wish to select a destination within
the displayed location, immediately se-
lect ROAD or CENTRE.
X If your destination is located else-
where, select the place using the right
rotary control and press to confirm.
X Select the letters one after another by
turning the right rotary control
press to confirm. The selected letter
appears enlarged at the right of the dis-
play.
Use multifunction button
the last confirmed letter.
The complete entry can be deleted by
pressing multifunction button
more than 2 seconds.
Already entered letters are displayed in-
versely. For the purpose of support, the
name of the location closest to the previ-
ous entry is displayed. The unit offers
only the possible remaining letters for
selection. If no other entries are availa-
ble, the unit completes the place name
automatically.
X To accept the entry, press and hold the
right rotary control
and
2 seconds or select the small tick
and briefly press the right rotary
control .
to delete
If the complete location name has been
entered or completed automatically; i.e.
for
the location entered exists only once in
the country of destination, the unit will
switch automatically to either the place
selection list or the Road/ Centre entry.
If there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
If an incomplete location entry was con-
firmed, the location selection list is dis-
played.
The location name most similar to the
for more than
entry appears in capital letters in the lo-
cation selection list.
The scroll marks indicate that other loca-
tions, sorted in alphabetical order, can be
selected.
A selection can be made by turning the
X
right rotary control
confirm. (See "General instructions"
on page 122.)
Navigation mode
and pressing to
125