Becker Indianapolis Pro 7950 Operation Manual page 120

Installation Guide
Status of the calibration journey (
In the Service Mode, select
ry control and press to confirm.
The calibration status (i.e.
(i.e. ) are displayed. After calibration is completed, instead of
3D
WHEEL and REV. , the road currently being driven on is displayed (pro-
vided it is included in the digital map).
Testing the system components (
A test program automatically tests the internal components of the navi-
gation system.
In the Service Mode, select
control and press to confirm.
If OK is displayed, press the
Service Mode.
Function test of the GAL signal, reverse signal, unit-internal sen-
SENSORS
sors ( )
• In the Service Mode, select
control and press to confirm.
• Move the vehicle several metres forwards or backwards for the
GAL signal function test.
!
The number value after
speed).
The number value after
vehicle is in neutral or when the accelerator is pressed while the
vehicle is parked.
120
CALIBRATION RIDE
CALIBRATION RIDE with the right rota-
) and the type of positioning
STATUS: 2
MODULE TEST )
with the right rotary
MODULE TEST
button. The unit switches back to the
with the right rotary
SENSORS
WHEEL must increase (also at low
WHEEL should not increase when the
)