Installation; Electrical Connection - Baumatic MG1 Instruction Manual

INSTALLATION

INSTAL LATION
The installation must be carried o
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European No
Replacements.
o Building Regulations (issued by the Department of the
Environment).
Building Standards (issue
o
Department).
o IEE Wiring Regulations.
o Electricity At Work Regulations.
Before con necting the appliance, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
WA RNING: THIS APPLIANCE MUST BE EARTHED.
This appliance should be wired into a 16 A double pole switched
o
fused spur outlet, having 3 mm contact separation and placed in
an easily acc
outlet must still be accessible even when your oven is located in
its housing.
To connect the oven power cord, loosen and remove the cover
o
on the terminal block, in order to gain access to the contacts
inside. Make the co
cable clamp provided and then immediately close the terminal
block cover again.
If you have to ch
o
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
Care must be taken to ensure that the temperature of the mains
o
supply cable does not exceed 50°C.
If the mains supply cable is dam
o
by an appropriate replacement which can be obtained from the
Baumatic Spares Department.
d by the
essible position adjacent to the appliance. The spur
nnection, securing the cord in place with the
ange the oven power cord, the earthing
23 23
ut by a suitably
Scottish Development
aged, then it must be replaced
rm