Installation - Baumatic BM90S User Manual

Cooking Guide
NB: cooking times are approximate and may vary according to personal taste .When cooking using the grill or fan
assisted grill ,the dripping pan must always be placed on the 1st oven rack from the bottom.

Installation

Only a qualified person in compliance with the instructions provided must install the appliance.
Appliance are fully assembled as in normal operation without any parts removed. The manufacturer declines all
responsibility for improper installation, which may harm persons and animals and damage property.
Important:
- The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it;
- Air duct is supposed to use in Ventilation.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate.
The figure below gives the dimensions of the cut-out for installation under the counter.
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed.
The oven must have a 40mm clearance between the oven and the rear timber panel.
The panels of the adjacent cabinets must be made of heat-resistant material. In particular ,cabinets with a veneer
exterior must be assembled with glues which can withstand temperatures of up to 100ºC.
In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it
has been installed. The oven must be secured by 4 screws to the cabinet.
Oven and Cabinet Dimensions
Important Installation Information
NOTE: Optimum ventilation will ensure
cabinets and oven components to remain
cooler and prevent possible overheating
(A)
of the oven.
A cut out (A) located under the oven of
700mm wide by 400mm deep is required
as a minimum. This will promote cooler air
to circulate around the oven during use.
Failure to do so could void the warrant.
Baumatic BM90S 900mm Built-In Oven User Manual 21