Honda Odyssey Owner's Manual page 238

Playing the AM/FM Radio (EX and EX-L models without navigation system)
To Play the AM/FM Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the AM or
FM button, or AM/FM button. On
the FM band, ST will be displayed if
the station is broadcasting in stereo.
Stereo reproduction in AM is not
available.
On the AM band, AM noise
reduction turns on automatically.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
TUNE Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency.
SEEK The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it
press the or side of the bar,
then release it.
2010 Odyssey
SCAN The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 5 seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 5 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
CONTINUED
235