Setting Up The Projector Address (Only If Necessary) - Barco iD H250 Owner's Manual

5. Setup
For example : if the projector address is 3, then press "3" on the RCU to set the RCU's address to match the
projector's address.
Common address/Projector address : Beside the projector address, the projector disposes also of a Common
address which can be set to "0" or "1" (by default "0").
In other words, an RCU set to address "0" will always control a projector regardless of its projector address
(since it uses the common address).
5.5

Setting up the projector address (only if necessary)

What can be done ?
The projector is shipped with projector address set to "0"
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu Projector Address, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
For more info on addresses see the appendix
How to change the projector's address ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Projector address
Image 5-5
5. Press ENTER
30 R59770079 BARCO ID H250/500 23/07/2007