DFI LanParty nF4 User Manual page 56

2
Hardware Installation
Serial (COM) Port
2
1
1
9
The system board is equipped with a 9-pin connector for connecting
an external serial port. The serial port cable is an optional item and
must be purchased separately. Insert the connector that is attached
to the serial port cable to the 9-pin connector then install the serial
port bracket to an available bracket slot at the rear of the system
chassis. Make sure the colored stripe on the ribbon cable is aligned
with pin 1 of the connector.
The serial port is an RS-232 and/or RS-485 asynchronous communi-
cation port with 16C550A-compatible UARTs that can be used
with modems, serial printers, remote display terminals, and other
serial devices.
56