DFI LanParty nF4 User Manual page 108

3
BIOS Setup
DRAM Drive Strength
This field is used to select a level of the DRAM drive strength.
Max Async Latency
This field is used to select the DRAM maximum asynchronous
latency time.
Read Preamble Time
This field is used to select the time prior to the max-read DOS
return when the DOS receiver is turned on.
Idle Cycle Limit
This field is used to select the cycle of MemCLKs before forcibly
closing (precharging) an open page.
Dynamic Counter
This field is used to enable the dynamic idle cycle counter.
R/W Queue Bypass
This field is used to select the number of times the first operation in
the DCI read/write queue can be bypassed before the arbiter is
overridden and the first operation is chosen.
Bypass Max
This field is used to select the number of times the first entry in
DCQ can be bypassed in arbitration before the arbiter choice is
disallowed.
32 Byte Granularity
This field is used to determine whether the burst counter should be
enabled to optimize data bus bandwidth for 32-byte access.
108