Setting The Clock; Preset Programme; Accepting The Preset Programmes; Programming The Unit - Danfoss SET 3E User Manual

1.3 Setting the Clock

• Move the slider to SET TIME
position.
• Use and
correct time.

1.4 Preset programme

The unit is supplied with the following preset programme which will
be active after the unit has been RESET (see page 6):
ON at 6:30am, OFF at 8:30am.
ON at 5:00pm, OFF at 10:30pm.
To alter these times to suit your requirements, follow the instructions
below.

1.5 Accepting the preset programmes

If you are happy to use the preset
programmes above you don't need
to do anything else.
Just return the slider to the
RUN position.

1.6 Programming the Unit

You can programme your heating and hot water to come on and go
off twice a day, to suit your requirements. To programme your unit:
• Move the slider to the 1st ON
position and use
to set the time you want the
programmer to fi rst come on.
• Move the slider to the 1st OFF
position and use
to set the time you want the
programmer to fi rst go off .
Danfoss Heating
keys to set the
and keys
and keys
GB
7