Setting The Clock - Danfoss 3020P Installation & User's Instructions

2 Still holding the central knob, move the blue tappet
marked 'B' to the time you want your HEATING/HOT
WATER to switch off in the morning.
3 You can set your other two tappets in the same w ay
to set your HEATING/HOT WATER for the afternoon
or evening.
EXAMPLE
(NB. Clock is in 24 hour mode)
If you want your heating and hot water ON between
7am and 10am and ON again between 5pm and
11pm, set tappets as follows:

Setting the Clock

o Turn the dial clockwise
until the correct time
is lined up with the dot
labelled TIME
NB. clock is in 24 hour
mode
!
8
A at 1st ON time = 7
B at 1st OFF time = 10
C at 2nd ON time = 17
D at 2nd OFF time = 23
REMEMBER
You will have to reset the time after a power
cut and also when the clocks change in
Spring and Autumn