Instructions For Use - Baumatic AS6.1 User And Installation Instructions Manual

USER INSTRUCTIONS
These User Instructions should be retained for future reference and for use by a person who is
perhaps unfamiliar with the appliance.
The following models are covered by these instructions:
AS6.1
B14
USING THE HOB
The symbols on the Control Panel fascias show which hotplate the control system operates. A
pilot light indicates when a hotplate is switched on.
AS6.1, B10, B12
Rotate the control knob that corresponds to the hotplate to be used, from the position '0' to the
required temperature setting. The higher the number, the higher the heat output.
Every cooking zone has a corresponding Residual Heat Indicator neon (to be found at the front of
the hob on the right hand side). The neon will light up when the corresponding cooking zone
becomes hot, and will remain lit until the temperature on the cooking zone has dropped below
50°C.
B13, B14, B15, B16
These hobs feature 'touch controls' and incorporate a safety lock system indicated by the key
symbol.
1. It is necessary to initially programme the system by touching the ON / OFF pad for 3
seconds. An audible 'bleep' will be emitted and the adjacent neon will light.
The desired cooking zone selection can now be made, however if a selection is not made
within approximately 10 seconds the hob will automatically switch OFF.
2. To switch on the cooking zone selected, touch the corresponding zone identification pad and
regulate by pressing either the + or – pad. The power level is indicated by LED symbols (1 =
minimum through to 9 = maximum). An audible 'bleep' will be emitted at each operation.
3. To switch OFF the cooking zone selected, press the – pad until all the LED symbols are
extinguished. Alternatively, pressing the ON / OFF pad will shut down any cooking zone in
use and turn off the hob.
4. After use, the H symbol will remain lit in the corresponding zone identification pad to
indicate residual heat. This will switch off when the temperature drops below 50°C.
5. To prevent accidental use of a cooking zone, the key lock system can be activated. Do so by
pressing the KEY LOCK pad once. An audible 'bleep' will be emitted. The LED adjacent to
the pad will illuminate indicating that the lock is engaged. All cooking zones will be disabled
and any previous temperature settings will be maintained.
These settings can be amended after disengaging the lock system, making the required change
and re-engaging the lock system.
The lock system can be overridden by pressing the ON / OFF pad which will shut off the hob
and cancel any temperature settings.
6

INSTRUCTIONS FOR USE

B10
B15
B12
B16
B13