Asf Unit Removal - Epson R200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R200/R210

2.3.3 ASF Unit removal

o
External View
C.B.S 3x6 (5-7kgf/cm)
C.B.S 3x6 (5-7kgf/cm)
C.B.P 3x8 (5-7kgf/cm)
Backside
Screw, Frame, Main 3x6 (5-7kgf/cm)
C.B.P 3x6 (3-5kgf/cm)
Paper Return Lever
1
Extension Spring 0.45
Figure 2-6. ASF Unit removal
DISASSEMBLY AND ASSEMBLY
C.B.S(P4) 3x6 (5-7kgf/cm)
Screw, ASF (4-5kgf/cm)
ASF Unit
Acetate tape
CN14
CN11
Board, Main
Support Plate, Frame, ASF
Torsion Spring 6.45
2
Roller, Retard Assy.
o
Parts/Units which should be removed before removing "ASF Unit"
Paper Support Assy./Housing (left/right)/Housing (frame)
o
Disassembly Procedure
1. Disconnect the PG sensor connector cable & the CDR tray sensor cable from
the connector (CN14/CN11) of the "Board, Main".
2. Remove the screws (x5) for securing "ASF Unit", and remove "ASF Unit" to
the backside of the printer.
3. Remove the screws (x3) for securing the PG sensor connector cable & the
CDR tray sensor cable to ASF frame, and release the cables.
4. Remove the ASF unit backward.
5. Open "Hopper" and then remove "Compression Spring, 2.51".
6. Bow slightly down "Paper Return Lever" and release the dowels (x2) on the
both sides in the order of
When removing "Paper Return Lever", the spring washer will
detach and drop. Take care not to lose it.
7. Remove the screws (x2) for securing "Support Plate, Frame, ASF".
8. Release the hooks (x2) for securing "Extension Spring, 0.45", and remove
"Roller, Retard Assy.".
Disassembly
Revision A
1 2
, ., and remove "Paper Return Lever".
40