Power Supply Unit Removal - Epson R200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R200/R210

2.3.13 Power Supply Unit removal

o
External View (The P/S Unit in figures is for Kubrick.)
Power Supply Unit C.B.P 3x10 (6-8kgf•cm)
C.B.S 3x6 (6-8kgf•cm)
5
4
Hooks
Figure 2-37. "Power Supply Unit" removal
o
Parts/Units which should be removed before removing "Power Supply Unit"
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Main Board/
Holder, Shaft Unit/Printer Mechanism
DISASSEMBLY AND ASSEMBLY
Shield Plate, Upper
2
1
3
C.B.S 3x6 (6-8kgf•cm)
C.B.S 3x6 (6-8kgf•cm)
1 4
3 2
Disassembly
o
Disassembly Procedure
1. Remove the screw (x1) for securing "Power Supply Unit". Then, remove
"Power Supply Unit".
2. Remove the screws (x5) which secure "Shield Plate, Upper".
3. Release the hooks (x2) which secure "Shield Plate, Upper", and then remove
"Shield Plate, Upper".
4. Remove the screws (x4) which secure "PSB/PSE Board", and then remove
"PSB/PSE Board".
o
When reinstalling "PSB/PSE Board",
n
Make sure to screw in the order as shown in the figure.
o
When reinstalling "Shield Plate, Upper",
n
Check if the "Power connector cable" is in between the two
shield plates.
n
Check if "Shield Plate, Upper" is correctly installed.
n
Make sure to screw in the order as shown in the figure.
o
When replacing "Power Supply Unit" with a new one,
implement the following adjustment. (Refer to Chapter 3
"ADJUSTMENT")
n
Offset Input for CR Motor Calorific Limitation
Revision A
61