Customize Email Antivirus And Notification Settings - NETGEAR UTM9S Reference Manual

2. In the Email section of the screen, select the protocols to scan by selecting the Enable
check boxes, and enter the port numbers if different from the default port numbers:
• SMTP. Simple Mail Transfer Protocol (SMTP) scanning is enabled by default on
port 25.
• POP3. Post Office Protocol 3 (POP3) scanning is enabled by default on port 110.
• IMAP. Internet Message Access Protocol (IMAP) scanning is enabled by default on
port 143.
3. If a protocol uses a port other than the standard service port (for example, port 25 for
SMTP), enter this nonstandard port in the Ports to Scan field. For example, if the SMTP
service on your network uses both port 25 and port 2525, enter both port numbers in the
Ports to Scan field and separate them by a comma.
The following protocols are not supported by the UTM:
• SMTP over SSL using port number 465
• POP3 over SSL using port number 995
• IMAP over SSL using port number 993
4. Click Apply to save your settings.

Customize Email Antivirus and Notification Settings

Whether or not the UTM detects an email virus, you can configure it to take a variety of
actions (some of the default actions are listed in
notifications, emails, or both to the end users.

To configure the email antivirus settings:
1. Select Application Security > Email Anti-Virus. The Email Anti-Virus screen displays:
ProSecure Unified Threat Management (UTM) Appliance
Content Filtering and Optimizing Scans
Table 38 on page 176) and send
179